Error Code: C C Difficulty: Moderate
Problem: Cooling Cassette filter needs replacement.
How to Fix C C Error (Step-by-Step)
- First, attempt to reset the code by replacing the cooling cassette filter (PureAir filter) located inside the fresh food compartment.
- After replacing the filter, press and hold the ‘Filter Reset’ button on the control panel for 3-5 seconds.
- If the code persists, unplug the refrigerator from the wall outlet for 5 minutes to reset the electronics.
- If the code returns after plugging it back in, the issue is likely the main control board or the display board, which requires replacement.
- Unplug the unit again. The main board is on the back behind an access panel, and the display board is behind the user control panel.
- Carefully photograph and disconnect all wire harnesses from the faulty board, remove it, and install the new one.
- Reconnect all wires exactly as they were, reassemble the panels, and restore power.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
What to Check Next on This Frigidaire Refrigerator
Focused repair path: refrigerator door, airflow, sensor, defrost, dispenser, and control checks. Do not treat this as a reset-only problem if the code keeps returning; use what the appliance does during the failed part of the cycle to choose the next check.
- Confirm the doors close fully, the gaskets seal, and the display is not reacting to a door left open or a blocked switch.
- Check for blocked vents, heavy frost, stalled fans, warm compartments, or recent power interruptions before replacing electronic parts.
- If the code involves temperature or airflow, inspect the evaporator fan, thermistor, defrost path, wiring, and control connections.
- If the symptom follows a door or dispenser event, check the switch, harness, hinge wiring, and connector seating first.
- Use the full Frigidaire refrigerator model number before buying parts because sensors, boards, fans, and switches are model-specific.
Check, inspect, clean, test, measure, remove, reconnect, clear, and replace parts only when the symptom supports that path. If these checks point toward a part, verify the complete Frigidaire model number from the appliance tag before ordering. The same error wording can use different valves, sensors, pumps, motors, heaters, locks, switches, or control boards depending on the exact model.
Recommended Replacement Part
- Main Control Board
When It’s Better to Replace Than Repair
Refrigerator repairs can become costly when sealed-system, control, defrost, fan, or ice-maker issues repeat.
Confirm width, height, depth, door swing, counter-depth needs, water line, and delivery path before ordering.
For repair parts, verify exact fit with the full refrigerator model number before buying; these links are general replacement-appliance shopping options.
- [OK]Water inlet valve, ice maker, or fan failures keep returning
- [OK]Defrost heater, thermostat, or sensor faults stack up
- [OK]Compressor or sealed-system repair is not economical
- [OK]Food-loss risk is becoming a pattern
Recommended Refrigerator Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.
More options (for a better recommendation)
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Frigidaire model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →Browse all Frigidaire error codes: Frigidaire Error Codes

