Error Code: E17 Difficulty: Moderate
Problem: Lint screen temperature sensor (NTC) error.
How to Fix E17 Error (Step-by-Step)
- Disconnect the power to the dryer by unplugging it and confirm the error stays cleared during a full test cycle.
- The lint screen NTC sensor is located in the lint filter housing. Remove the lint screen to access it.
- You may need to remove the top or front panel to get to the sensor’s wiring.
- Disconnect the wire connector from the NTC sensor and confirm the error stays cleared during a full test cycle.
- Remove the screw or clip holding the sensor in place and remove the old sensor.
- Install the new NTC sensor and secure it and confirm the error stays cleared during a full test cycle.
- Reconnect the wire connector, reassemble the dryer, and restore power.
- Turn the appliance off, wait about 2 minutes, then turn it back on.
Recommended Replacement Part
What to Check Next on This Bosch Dryer
Use these checks before ordering parts for Bosch dryer E17. They keep the diagnosis tied to the appliance instead of turning the page into a reset-only guide.
- Unplug the dryer before touching the lint housing, rear vent, lower service area, or any wiring.
- Clean the lint screen, moisture sensor bars, condenser area if equipped, and the full vent path so airflow problems do not imitate part failures.
- Run a short timed cycle with a light load and note whether the fault appears immediately, after heating starts, or near the end of the cycle.
- If the fault returns with clean airflow, inspect the part categories below using the full model number from the dryer tag.
- Stop repeated test cycles if you smell heat, see moisture near electrical areas, or hear grinding from the drum drive.
⚡ Don’t Risk a DIY Fail!
Get the ‘Secret Service Mode’ Cheat Sheet for your Bosch model. Includes an easy-to-read list of every error code and quick diagnostic tips.
✅ Join 15,000+ DIYers • Instant PDF Download
Browse More Codes
📖 View All Error Codes
Expert: Mike Sullivan
EPA Section 608 Certified Technician with 18+ years experience.
Read Editorial Standards →When It’s Better to Replace Than Repair
Dryer repairs are often worth it for small parts, but repeated heating, motor, drum, or control failures can point toward replacement.
Confirm gas vs electric, venting, voltage, doorway clearance, and laundry-space dimensions before ordering.
For repair parts, verify exact fit with the full dryer model number before buying; these links are general replacement-appliance shopping options.
- [OK]Thermal fuse or heater failures keep returning
- [OK]Belt, roller, or motor repairs exceed unit value
- [OK]Door switch or control issues stack with other faults
- [OK]Older dryer has long dry times even after vent cleaning
Recommended Dryer Replacement Options
As an Amazon Associate, we earn from qualifying purchases.
Leave a Reply