How to Fix Amana Washer Error F3 E2

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: F3 E2 Difficulty: Easy

Problem: Inlet Water Temperature Fault

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

no_parts

How to Fix F3 E2 Error (Step-by-Step)

Check the water inlet hoses at the back of the washer.
Ensure the hose connected to the hot water faucet is attached to the ‘H’ or ‘Hot’ inlet port on the washer.
Verify the hose connected to the cold water faucet is attached to the ‘C’ or ‘Cold’ inlet port.
Make sure both water faucets are turned on completely and confirm the error stays cleared during a full test cycle.
Straighten any kinks or bends in the water hoses that could be restricting flow.
Restart the washer to see if the error is cleared.
Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Amana model. Includes an easy-to-read list of every error code and quick diagnostic tips.