How to Fix Frigidaire Washer Error E13

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: E13 Difficulty: Hard

Problem: Water leak in the tub or air leak in the pressure sensor air hose.

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

$100 – $250 Range

How to Fix E13 Error (Step-by-Step)

Unplug the washer from the electrical outlet and turn off the water supply valves.
Disconnect the hot and cold water hoses and the drain hose from the back of the washer.
Carefully tilt the washer backwards and prop it securely against a wall to access the bottom.
Locate the drain pump at the bottom of the machine. Disconnect the wire harness and the hoses attached to it, having a towel ready for residual water.
Remove the screws mounting the old drain pump and install the new one in its place.
Reconnect the hoses and wire harness to the new pump.
Carefully set the washer upright, reconnect all hoses, and plug it back in.
Turn the appliance off, wait about 2 minutes, then turn it back on.

OEM Part #: 137108100 (Drain Pump)

Estimated Market Price: $124-$151

Verified Compatible Alternatives:

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

Get the ‘Secret Service Mode’ Cheat Sheet for your Frigidaire model. Includes an easy-to-read list of every error code and quick diagnostic tips.