How to Fix Frigidaire Washer Error E32

Error Code: E32 Difficulty: Moderate

Problem: Water level pressure sensor isn’t communicating with the electronic control board or there is a pressure sensor calibration problem.

How to Fix E32 Error (Step-by-Step)

1. Disconnect the washer from the wall outlet to ensure your safety during the repair.
2. To access the internal components, you will typically need to remove the top panel of the washer by unscrewing fasteners at the back.
3. Locate the water level pressure sensor; it is a small, round part with a thin air hose and a wire connector attached.
4. Carefully disconnect the wire harness by pressing its release tab and pull the thin rubber air hose off the sensor’s port.
5. Remove the screw or release the clip holding the sensor to the washer’s chassis and remove the old sensor.
6. Mount the new pressure sensor, then firmly reconnect the air hose and the electrical wire harness.
7. Reinstall the top panel, plug the washer in, and run a test cycle to confirm the fix.
8. Turn the appliance off, wait about 2 minutes, then turn it back on.

Still Not Working?
If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Browse all Frigidaire error codes: Frigidaire Error Codes