How to Fix Kenmore Refrigerator Error 6 BLINK

Written by

⚠️ Safety Warning: Appliance repair involves electricity, gas, and moving parts. Always disconnect power before working on any appliance.

Error Code: Refrigerator Difficulty: Hard

Problem: Compressor overload or start system failure (795 series flash code)

⚖️ Repair Decision

⚠️ CHECK WARRANTY / AGE

$100 – $250 Range

How to Fix Refrigerator Error

UNPLUG unit for 30 minutes to allow compressor thermal overload to reset.
Restore power and listen for compressor attempting to start (brief hum then shutdown indicates overload).
Remove rear access panel to access compressor.
Replace start relay/overload kit first (least expensive component).
If compressor still won’t start, test compressor windings for shorts/opens (requires multimeter).
If windings good but compressor locked (won’t rotate shaft with screwdriver), install hard start booster capacitor as temporary fix.
If windings shorted or compressor seized permanently, requires sealed system repair by licensed technician (refrigerant handling required).
NEVER operate compressor with hard start device for >30 days – causes permanent damage.

OEM Part #: WPW10864843

Estimated Market Price: $150-280

If the replacement part didn’t fix the issue, you may have a wiring problem or main board failure.

Get the ‘Secret Service Mode’ Cheat Sheet for your Kenmore model. Includes an easy-to-read list of every error code and quick diagnostic tips.

✅ Join 15,000+ DIYers • Instant PDF Download

Appliance Type

Appliance Age

Estimated repair cost (parts, or parts + labor) Most DIY parts are $50–$250. If you have a quote, use the total.

Is it under warranty?

More options (for a better recommendation)

Brand

Your DIY Skill Level

EPA Section 608 Certified Technician with 18+ years experience.

Browse all Kenmore error codes: Kenmore Error Codes